Healtech gear indicator and advanced timing retard eliminator GIpro ATRE G2 for Suzuki GSX-R 1300 Hayabusa 99-20 with bike specific cable model HT-GPAT-S02

This combo unit is not only the most advanced gear indicator on the market, but also the best TRE (Timing Retard Eliminator) device available for selected Suzuki, Kawasaki and Triumph motorcycles. Get more power while smartening your ride up at the same time! Switch between 7 modes (+ bypass) with the help of the new touch sensor on the top of the unit.

Note: On 1000cc+ Suzuki models, including the GSX-R1000 and the Hayabusa, it even acts as a top speed de-restrictor. Get the max out of your ride with this simple yet effective and stylish mod. (TRE is disabled by default. To comply with local regulations, do NOT activate TRE mode on public roads!

Instant and accurate indication of the selected gear for added control and safety. The sampling period can be adjusted to make the response quicker or slower, depending on shift speed and signal conditions..

All settings can be done via the touch sensor so there’s no opening on the housing, it is completely sealed and encapsulated in epoxy. The touch sensitive area is on the TOP of the unit. However, after programming, the unit can be mounted even with the top side stuck to the dashboard (via the sticky pads supplied) and will function properly. It can also be used with the optional GIpro Mount.

Plug ‘n Go wiring harness, easy to mount display. Complete installation can be done within 30 minutes on most motorcycles.

Extra bright LED display, housed in a compact box. Available in 5 colors.

The brightness of the display is adjusted automatically according to the ambient light intensity. The sensitivity of the sensor can be fine-tuned in the menu.

With activated TRE (Timing Retard Eliminator) both throttle response and acceleration are improved in the lower gears. Also, the bike’s top speed limiter is disabled on 1000+ cc bikes. TRE automatically switches off in Neutral for smooth idle operation and switches back to the selected mode when the gearbox is in gear. If a TRE device is installed on a bike equipped with in-dash gear indicator, the bike’s indicator will show the mapped gear. However, the GIpro will indicate the gear selected regardless whether the built-in TRE is active or not. TRE is disabled by default. To comply with local regulations, do NOT activate TRE mode on public roads.

The unit is pre-programmed to fit most motorcycles and it works out of the box. However, if needed, it learns the gear positions automatically, just start the learning function via the menu.

FEATURES:

– Full SMT-design, encapsulated in epoxy

– 100% waterproof (IP68)

Select in the option the colour for the display that you prefer.